Test it on a "known good" router with a CSU/DSU (T1 interface). Put the Cat 5 end into the crimper and verify all of the wires are pushed all the way into the pin slots and then crimp it down.ĩ. You should now have 2 wires "looped" in the cat 5 blank end with pin 1 connecting pin 4 and pin 2 connecting pin 5Ĩ. Put one end of the second wire into pin 2 and bend it in half and put the other end into pin 5.ħ. Put one end of the first wire (either one will do) into pin 1 and bend it in half and put the other end of it into pin 4.Ħ. If you are looking at it this way, the bottom slot is pin 1 and the top is pin 8.ĥ. Identify the pin order on the Cat 5 end: hold it with the movable/press-side of the clip away from you and the metal contacts facing left. usually same colors (brown and brown/white, etc.)Ĥ. Cut off about 2 to 4 inches of a Cat 5 cableģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |